Check-in inspection
Vehicle condition, paint type, existing marks and customer priorities are checked before the service scope is confirmed.
Ceramic Coating
Gloss, maintenance and controlled preparation.
Ceramic coating is not a stone-chip solution. It is a finish-care system for paint clarity, hydrophobic behaviour, easier washing and a cleaner long-term ownership routine.
Surface preparation
Coating is only as good as the finish underneath.
We treat ceramic coating as a detailing process first. The vehicle is washed, decontaminated, inspected, corrected where needed, wiped down and then coated under controlled lighting so the final gloss has a clean foundation.
Detailed process
The full preparation path before coating is applied.
The visible coating layer is the last part of the job. The result depends on the cleaning, correction and inspection stages that happen before it.
Pre-rinse and safe wash
The exterior is rinsed and washed with a low-contact method to remove loose dust, road film and daily contamination.
Panel gaps and emblems
Edges, badges, trims, mirrors, door shuts and tight areas are cleaned so residue is not trapped beside the coated paint.
Wheels and arches
Wheels, tyres, arches and lower impact areas are cleaned separately to remove brake dust, tar and heavier road grime.
Chemical decontamination
Iron fallout, tar and bonded contaminants are reduced before the paint is touched with clay or correction tools.
Clay and glass prep
Paint and exterior glass are prepared where required so the surface feels clean and ready for inspection under light.
Drying and masking
Water is cleared from seams and trims. Sensitive plastics, rubber and edges are protected before polishing begins.
Paint correction
Machine polishing is matched to the vehicle condition to improve gloss, remove oxidation and reduce visible wash marks.
Panel wipe reset
Polishing oils and residues are removed so the coating bonds to the prepared surface rather than sitting over product residue.
Coating application
The selected ceramic coating is applied section by section, then levelled with controlled timing and clean towel work.
High-spot inspection
Panels are checked under lighting for streaks, missed edges, uneven levelling and residue around trim lines.
Cure and handover
The vehicle is allowed to settle before handover. Aftercare guidance is provided so washing and drying do not undo the work.
Google reviews
Recent coating and detailing feedback.
Google Rating
Rating + reviews
Google rating, review count and coating comments connect here.